Eemann Tech Sear Spring Installation Tool for TANFOGLIO
Eemann Tech Sear Spring Installation Tool for TANFOGLIO
Eemann Tech Sear Spring Installation Tool for TANFOGLIO

Eemann Tech Sear Spring Installation Tool for Tanfoglio

Brand: Eemann Tech

Reference: ET-150007

RRP: 33.50 €

Eemann Tech sear spring installation tool for TANFOGLIO pistols and their clones.

The Eemann Tech sear spring tool will revolutionise your sear spring installation.

Either for general maintenance or because your spring broke, on the range or in your workshop, this tool will simplify a normally very tricky job and substantially reduce the time it usually takes. 

You can replace or install your sear spring in seconds without any experience. We recommend the installation of the Eemann Tech Competition sear spring part number ET-151930.

The new Eemann Tech sear spring tool incorporates a tiny neodeum magnet which holds the sear spring very securely whilst the short leg of the sear spring rests in a micro hole within the tool.
There are special relief cuts in the tool that allow it to be positioned correctly for the installation.

The tool is made of brass that is softer than the spring thus will not damage it, but it’s hard enough to perform the task.

Compatible with all TANFOGLIO pistols :

• STOCK 1,2,3
• Custom, Limited Custom
• Xtreme all models
• Unica and their models

Material: Brass

How to use the tool, check our special video on youtube channel. 


https://www.youtube.com/eemanntech